This connection provides accessory power for an optional DSP.ДSP Power Sub Harness.

Front and rear high voltage balanced (speaker level) RCA out from factory radio. So there is no need to go looking for additional wire connectors. Integrated wire connectors function both as butt connectors for amplifiers with pigtail speaker connections as well as wire ferrules for amplifiers with Allen screw-type speaker connections. Speaker connections for an aftermarket amplifier.DSP accessory, battery, and ground output.100% developed and designed by American Hard Bag in the USA.Wire ferrules and crimp connectors built into the harness.Accessory, battery, and ground outputs for powering DSP without the need for any additional parts or plugs.Built-in load resistors keep factory radio happy and eliminate distortion.Front and rear speaker connections for factory locations.Both front and rear (4 Channel) RCA out from factory radio (balanced speaker level on RCA, requires an amplifier or DSP that is designed to accept speaker level in on RCA connection).True Plug & Play! No cutting any factory wires.Does not work with Sound Digital, Dayton, and DS18 amplifiers (direct plug into the amp) Balanced speaker level on RCA, requires an amplifier or DSP that is designed to accept speaker level in on RCA connection (most all quality amplifiers and DSPs do accept speaker level, but check your equipment to make sure).В CVO and bikes that only have fairing speakers will require a radio flash to enable the rearВ RCA output.

Amplifier bypass plugs can be found here. Amplifier bypass plugs required for all factory amplified systems. This harness gives you all of the connections and features you could want and it works with all variations of Harley stereo systems from basic to CVO Ultra models, both factory-amplified and non-amplified.ДЇitment: 2014 and up Road Glide, Street Glide, Electra Glide, Ultra, CVO, and all amplified and non amplified variations. True Plug & Play! This is the very best way to integrate an aftermarket amplifier with the factory radio of any '14 or newer Harley bagger. This Is the Part You Need! Adding an Amplifier to Your 2014 or Newer Harley Davidson Touring Bike Has Never Been Easier. For instance, if your voltmeter says 10 volts and you know your speaker to be 4 ohms then simply calculate 10 volts times 10 volts which is 100, then. Description: Harley Davidson 14-current Factory Radio T Harness For a pretty close guestimate, it can be as simple as hooking a voltmeter to your speaker leads when you play your amplifier and using the formula voltage times voltage divided by impedance.

Amp output factory radio